SHARKDIV flasher

ESP32-S3 / 16 MB / STABLE v1.7.37

  1. Use Chrome or Edge on desktop — the flasher needs Web Serial.
  2. Connect SHARKDIV with a USB data cable (not charge-only) and switch it on.
  3. Click Connect & Flash, pick the serial port, and wait. The screen lights up while it flashes — that keeps the board powered.
  4. If it hangs on connect: hold BOOT, tap RESET, release BOOT, then retry.
Ready.


        

        
Switches off mid-flash, or won't turn on?

The board's battery chip turns it off after about 30 seconds when it draws very little power — which is what happens with no firmware running, for example after a flash was cut short. Once the flasher connects it lights the screen, and that keeps the board on.

Try this first: tick Erase flash first, plug in USB, switch the board on and click Connect & Flash within about 20 seconds, before it cuts out. When the screen lights up, it will stay on until the flash is done.

Still switches off before it connects? Flash on USB power alone:

  1. Unplug the battery connector from the back of the board.
  2. Plug the USB data cable into the computer. The board now runs from USB and stays on.
  3. Tick Erase flash first, then click Connect & Flash. If no port shows up, hold BOOT, tap RESET, release BOOT.
  4. When it says Done, unplug USB, reconnect the battery and switch the board on.

ESP Web Tools

Alternate installer and serial console for stable v1.7.37. The main flasher above includes this board’s backlight power fix. For the alternate installer, use USB power with the battery disconnected if the board switches off.

Use a desktop browser with Web Serial to connect over USB. Open this page over HTTPS or localhost to use USB.

Merged image for 16 MB boards — bootloader, partition table and app in one file. Flashing takes 1–2 minutes at 115200 baud; don't unplug.
Trouble? Flash over USB with esptool — see FLASHING.md. Firmware: github.com/M5Shark/SHARKDIV-firmware See integration and license notes.